Backup Power Reviews

Make the right purchase

Can a battery run a gas or oil boiler in a power cut?

A 100 W electrical load would run for about 7.4 hours per 1 kWh of battery in our planning example. A gas or oil boiler may need less energy than electric heating, but a portable battery is only an option once a qualified installer has checked the whole installation.

Fuel supplies the heat; electricity makes the system work

A gas boiler still needs electricity for its controls and other components. An oil boiler also needs an electrical supply. Keeping fuel available does not keep the heating working through a power cut. Vaillant’s power-supply advice and Grant’s oil-boiler guidance explain that distinction.

The boiler’s heat rating is not its electrical demand. A 30 kW heat-output specification cannot be entered as a 30,000 W battery load. Nor can a figure for the boiler alone account for every separate pump, valve or controller in the heating system. Ask your installer to identify everything that must keep working.

Compatibility comes before a shopping list

Many boilers are connected to a fixed electrical supply. Do not convert that connection yourself, feed power into a household socket or improvise a neutral-to-earth connection. The source, earthing and protective devices must work together when the mains is absent. The IET’s guidance on protection in island mode explains why an inverter’s fault-current behaviour makes this a design question.

Ask a qualified electrician, working with the heating engineer where necessary, to approve the exact boiler, battery and changeover arrangement. A pure-sine-wave label, a UK socket and enough rated watts do not prove compatibility. Get the proposed connection and its installed cost settled before buying the station.

What runtime could the energy budget allow?

The following are illustrative steady electrical loads, not measured averages for gas or oil boilers. The calculation allows 85% of rated battery energy and adds 15 W of station overhead: hours = 1,000 × 0.85 ÷ (load in watts + 15). Use the measured combined demand of the approved setup in place of these examples.

Illustrative runtime for every 1 kWh of rated battery capacity
Combined electrical loadEstimated runtimeRated capacity for eight hours
50 W13.1 hours612 Wh
100 W7.4 hours1,083 Wh
200 W4.0 hours2,024 Wh

Those capacity figures are arithmetic minima under the assumptions, before extra reserve. Cycling changes the average, while starting components can require more power briefly. A cold house calling for heat for hours can produce a different budget from mild-weather monitoring. Check both energy and starting demand.

When would we shortlist 1 kWh or 2 kWh?

After installation approval, use the battery-size planner for the measured load and required hours. Our 1 kWh comparison suits a smaller budget with adequate reserve. At the 100 W example above, a nominal 1 kWh unit already falls short of eight hours; the 2 kWh comparison is the more relevant starting point.

These links compare energy, output and practical features. They are not a list of boiler-approved batteries. If the installer cannot support a portable station for your system, consider a purpose-designed backup installation or a plan for staying elsewhere. For warmth without operating central heating, see the separate heated-throw guide; that does not protect the building or its pipework.

Will a larger battery also run an electric boiler?

Electric heating takes its heat from the electrical supply. It is a different load from powering the controls of a fuel-burning boiler. Size and installation requirements rapidly exceed the portable setups discussed here. Our electric-heater examples show the energy cost even at 500 W.

Can I test it by pulling the plug?

Only follow a test procedure agreed for your installed system by the responsible professional and the equipment makers. This guide does not authorise altering fixed wiring or bypassing protective arrangements. Record the approved test, the actual load and the runtime before treating the setup as reliable backup.

Desk-based guidance using the named sources and labelled calculations. We have not tested a boiler installation or these systems ourselves. How we review.

Updated