Backup Power Reviews

Understand the evidence

Why a big power station can disappoint with a small load

For broadband, small lights and intermittent appliances, the station’s own power consumption can be as important as battery capacity. Look for low-load measurements and settings, not just the largest Wh number.

The sockets themselves have an energy cost

A portable station converts battery electricity into mains power through an inverter. Keeping that system active consumes energy even when an appliance draws very little. The cost continues while a fridge compressor pauses or a laptop finishes charging, unless the output turns off.

In a UK C1000 Gen 2 test, The Technology Man disabled the automatic AC saving mode and estimated roughly 17 W idle draw from a twelve-hour battery-level change. That is an estimate on one unit, not a calibrated efficiency curve or a figure for all Anker stations. The Technology Man: UK C1000 Gen 2 test

Why this changes the buying decision

Calculated runtime for a 1,024 Wh battery, 18 W appliance load and assumed 85% usable energy
Additional station overheadTotal modelled demandEstimated runtime
5 W23 W37.8 hours
15 W33 W26.4 hours
25 W43 W20.2 hours

These are sensitivity cases, not three tested products. They show why a headline capacity comparison is incomplete. Use the same definitions when comparing results: measured AC energy at a matching load already includes the station’s consumption during that test, so do not subtract it a second time.

Automatic shut-off can help or interrupt the job

An energy-saving timeout is convenient when an unused appliance has been unplugged. It is a problem if a fridge compressor is temporarily idle or a small router falls below the threshold. Check the relevant settings in the current manual and app, then test your setup for longer than the suspected timeout.

Turning off a timeout may keep the device running while increasing battery use. That trade-off should be part of the runtime budget. Do not assume a station will behave identically after a reset, firmware change or a change to its minimum charge limit.

When direct USB-C or DC helps

A compatible USB-C laptop can sometimes run directly without enabling the mains inverter. A portable fridge with a supported 12 V input may likewise avoid an unnecessary conversion. Both still have losses. Use the equipment maker’s approved lead and check voltage, polarity, current and connector requirements; an adapter that fits is not proof of compatibility.

What to buy for small loads

For phone charging, start with a power bank. For an existing mains-powered broadband setup, compare compact stations and insist on a realistic runtime budget. If you need a full working day with more equipment, move to the 1 kWh comparison.

We have not established a matched UK low-load winner across our shortlist. Buying a larger unit is a valid way to add reserve, but it should follow an energy calculation and a check that the output stays on.

Updated