Plan your setup
NAS battery backup: safe shutdown before extra runtime
For a NAS, start with a compatible UPS and a tested shutdown plan. A power station’s larger battery can offer more runtime, but a charging USB socket and a fast switchover claim do not establish NAS compatibility.
Two connections do different jobs
The mains lead supplies power. A supported USB or network data connection tells the NAS that mains power has failed and that it needs to stop safely. Without that information, a NAS can run for hours from a large battery and then lose power abruptly when the battery empties.
Synology documents USB UPS support and a Standby Mode that stops services and unmounts volumes. The exact features and settings depend on the NAS and software version. Follow the documentation for your system and confirm the specific UPS in the manufacturer’s compatibility information. Synology: UPS support and Standby Mode
Choose a recovery plan, not just a runtime
For most home archives, the objective is to finish writes and stop safely. Long runtime can be useful for a server you actively need, but it also brings the network switch, broadband equipment and client computers into the calculation. If the NAS receives shutdown information through a network, that communication path needs backup power too.
Decide what happens when power returns. Automatic restart, delayed shutdown and low-battery behaviour should all be checked in the relevant software. Keep a separate backup of important files: an electrical backup does not protect against accidental deletion, disk failure or ransomware.
How much battery is enough?
Use the NAS’s active draw with its installed disks, not just an idle specification. A hypothetical 35 W NAS and 10 W switch use 45 W. Ten minutes is only 7.5 Wh at the equipment, but a UPS’s runtime curve and ageing battery matter more than that simple energy number. Use the manufacturer’s curve at the actual load and leave a sensible shutdown margin.
If you really need hours, our planning assumptions of 85% usable energy and 15 W station overhead give around four hours from a 286 Wh station at that 45 W load. This is an energy calculation only. It says nothing about data signalling, compatibility or whether the sockets remain active at small loads.
What to investigate before buying
The APC Back-UPS BE650G2-UK is an example worth checking against your NAS’s supported UPS list and power requirement. It has battery-backed and surge-only outlets; equipment needing backup must use the former. We are not claiming it is compatible with every Synology or other NAS.
As an Amazon Associate I earn from qualifying purchases.
Check APC BE650G2-UK on Amazon UK (paid link)
The APC quick-start guide distinguishes the charging USB socket from a separate data port, which needs the appropriate RJ45-to-USB communication cable. The guide says that cable is not supplied in every box. Confirm the correct lead and NAS support before ordering; an ordinary network lead is not a substitute. APC quick-start documentation
APC UK specifications · UPS versus a portable station.
Only consider a station as the primary NAS backup after checking its supported data connection, software and behaviour at the chosen charge limits. Test your configured shutdown process with current backups and no important write operation in progress. Buying a larger battery cannot substitute for that check.